The other is composed of a special set of characters that will immediately command Grbl to do a task in real-time. One system command type is streamed to Grbl like g-code, but starts with a $ character to tell Grbl it's not g-code. However, Grbl also has two separate system command types that are outside of the normal g-code streaming. In general, Grbl assumes all characters and streaming data sent to it is g-code and will parse and try to execute it as soon as it can. Some users were setting this negative and it was causing Added a note in the defaults.h file that MAX_TRAVEL values mustīe positive. Fixed an issue when in inverse time mode and G0’s would require a Wrapped the mc_parking_motion() function in an ifdef for porting
The numerical round-off issue doesn’t effect it. Added a compile-time check for AMASS settings to make sure that
Motion command that is _one step_ in length, Grbl would not actuate the When AMASS is intentionally disabled and sent a Went unnoticed or why it worked up until now but it has. Properly declared system variables as extern. Previously this was blocked and was problematic for laser M4 is now allowed to work when USE_SPINDLE_DIR_AS_ENABLE_PIN isĮnabled. User enables the USE_SPINDLE_DIR_AS_ENABLE_PIN option. The new option turns theĮnable pin on and off with S>0 and S=0. Pin separately and leaves it on when S is 0. Spindle enable pin configuration option to alter its behaviorīased on how certain lasers work. Updated the CSV and documentation to reflect these Five new build info identification letters. `M56` appears in the $G report when enabled.
Requires ENABLE_PARKING_OVERRIDE_CONTROL and PARKING_ENABLE enabled in Parking motion override control via new `M56 P0` and `M56 P1`Ĭommand, which disables and enables the parking motion, respectively. V1.1f update due to tweaks to interface from new parking override
0 kommentar(er)
